Description
-Upgraded Bearing for Howe Upper Max A-Frames, features Nylon Cage and polished bearings.
-Standard steel cage creates binds over time compared to nylon cage where minimal lubrication is necessary.
 
Installation process: Pull end caps off of both sides with 1/2" drive ratchet, remove C-clips snap rings on outboard side of bearing, remove greaserk, slide control arm one way and remove bearing, slide control arm in opposite direction and remove second bearing, then remove control arm from cross shaft. Clean thoroughly then reassembly with upgraded bearings
 
Recommended Lubrication: Minimal amount of light synthetic grease or spray grease/gel lube/super penetrant. DO NOT OVER GREASE and DO NOT PUSH GREASE THRU OPEN HOLE. TAPE OR PLUG OPEN HOLE